- Frequently Asked Questions
- What is the Largest and Smallest CNC Turning Part Available?
- Uses for different Wire Gauges
- How to buy wire mesh
- Which Grade material is best?
- Why is chain-link fencing the best material for security fences?
- What Type of Barbed Wire Fences Do You Need?
- More>>
- Technical Information
- Technical Info of Perforated Metal
- Basical Elements to a CNC Project
- Stainless Steel Materials used for Machining
- Milling machine tooling
- Tips To Hot-dip galvanizing
- How to Install Fencing?
- More>>
- Screen Knowledge
- Computer numerical control
- Milling machine
- Two Methods to Measure the Particle Retention Size
- About the End Closures of the Cylinder Mesh Filter
- Features of perforated metal compared with expanded metal
- About the End Closures of the Cylinder Wire Mesh Filter
- More>>
- Payment Method
- T/T payment for small transaction on wire mesh
- Payment by L/C
- Payment methods
- More>>
Product Index: Home > Customer Service > Screen Knowledge > Screen Knowledge
About the End Closures of the Cylinder Mesh Filter
Cap Solder - the end of the filter is dipped in molten solder, which fills the end opening. This is relatively inexpensive, but is limited to cylinders smaller than approximately 1/4 " in diameter.
Fishtail Weld - the end is pinched together and welded. This is usually the least costly method and is used when the width of the end closure may exceed the outside diameter of the cylinder.
Flush Bottom - a wire cloth cup is attached to the filter with the bottom surface flush with the end of the cylinder.
Folded End - the end of the cylinder is folded and secured. Usually used with finer meshes and low to moderate volume.
Inverted Bottom - a wire cloth cup is attached to the end of the filter with the bottom surface recessed into the end of the cylinder. This method is usually less expensive than a flush bottom.
Running Crease - same as fishtail weld, except that the width of the end closure is confined.
